Pitbulls : Go Pitbull Dog Forums - View Single Post - Slat mill designs
View Single Post
Old 09-17-2014, 10:22 PM   #11 (permalink)
welder
scratchin hard
 
welder's Avatar
 

1x Welder\'s walk to end alzheimers
welder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninja
welder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninjawelder reputation ninja
na coach not you this time hahaha.



GAP; yea 1/8''is fine no more than that tho. you can use 1/16'' but you have to rout both top and bottom of the slats. you should do that regardless.

I use 3 screws per side. 1 in the middle at the seam of the belt and 1 on each side of the seam. or you can use 4 per side, 2 on each side of the seam. aint no dum questions, just dum answers lmao.....
__________________
100 men will test today.....................only 3 win the green beret.SF 76-81.
quote:aint nuthin n the middle a da road but a dead possom and a yellow stripe:Tom Langley,12-7-76.
welder is offline   Reply With Quote